Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I got a new PC with Windows 10 .... everything is good with this Windows EXCEPT I cannot run Ansys HFSS 2014 (v. 15) which is the main software I use for my research ...
I installed it but it always crashes once starting the software (HFSS) .... I cannot open any file ...
I tried the new...
One solution is to run the feed line separately with a 50 ohm lumped port or wave port at each end of the line. Use parametric analysis by changing the length of the line, from the resultant S11/S21 you can estimate the good length of the feed line which gives S11 < -20 dB and S21 > -0.5 dB in...
How can I change the drawing working plane in CST MWS (it is xy plane by default)?
Also, How can I enter my own data set (voltage vs time) as input excitation signal for a dipole antenna in Transient Mode?
Thanks a lot
Hussein Attia
Thanks a lot , volker_muehlhaus
I am guessing that the corresponding impedance of the (DC source) at 2.4 GHZ would be approximate open circuite
Am I right?
***** I am desperate **********
I am simulating (HFSS) an antenna working at 2.4 GHz (in its environment) and there is some DC voltage source to be included around the antenna
Any idea on how to include a DC voltage source in HFSS simulation?
keeping in mind that I want the sweep frequency to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
