Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Despite reading the spec sheet (and especially section 14.13.2) and although carefully following the steps, I cannot seem to get CCP1 pin RC2 to output a PWM signal.
All though there are many possible complex PWM bridge output configurations, I would really like to know how many single-output...
Thanks to everyone for your help. I have found the problem: attempting to write to outputs directly instead of using LATCx. With use of LATCx everything works fine.
NOTE: TMR1 is working correctly and blinking the LEDs it is supposed to.
I seem to have tried without success to initialize all pins of PORTA, PORTB, PORTC, to be just I/O pins set for only input-output mode.
In this program, every PORTB pin seems to blink properly except for PORTB.0 PORTB.1...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
