Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for your response.
Actually I was using lumped port and I happened to find the problem. Around my metal was not filled with anything, that was the problem! Below and above I had material but not around. That's it!
Hi guys
I am designing a very simple dipole antenna using HFSS. However I am not able to run the analysis.
Here is the problem; As you see, there is a port refinement problem. I have added integral line and everything is connected and there is no gap between port and my dipole antenna.
Please...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.