Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sorry I did not write at once. I work in submicron cmos process with a supply voltage equal to 2.5 V.
I use Cadence IC.
The main problem is that there should be zero current consumption (no more 10nA) when the supply voltage established and I can not use band-gap reference.
There are many...
Hi, I need to make "Zero standby-current power-on reset circuit".
Necessary to make the schematic, which works as follows:
If the supply voltage is smaller than 2.1 V, then the value at the
output is equal to the supply voltage, if the supply voltage is
greater than 2.1 V, then the output is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.