Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
When input to transfer function (1/s+1) at time zero is zero,how to get non-zero output from this function at simulation time zero in Simulink so that i can give to divider.
What will be output of a transfer function block used in Simulink as it is giving "zero" at time zero when I run the simulation although the input is connected.I have attached the image as well.
I am doing Simulink simulation in 3-Phase AC Induction Motor Drive using Vector Control Technique..I have made the model but when I am running it,it gives error in "Adder" block that it fails to initialize as can't find anything to start...Help me
Is simulation of FOC(vector control) 3 phase induction motor drive apllicable by pspice?
suggest me some good e book to read on drives and on pspice simulations specially for drives
Is it possible to do simulation of vector control(foc) 3 phase induction motor drive using pspice?
Can any one suggest me some link or book for that OR SOME GOOD BOOOK NAME FOR PSPICE WHICH IS AVAILABLE ON NET?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
