Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello guys
Now its possible to run challenging complex Model-Based Engine controls with this ECU powered by LabVIEW. Designers can do real-time implementation, rapid designing and development of an engine control unit (ECU) that comprises of all advance engine control technology. Thanks to...
Hello guys
I have a Motor equipped with an encoder, which can generate 3 pulses per revolution.
Encoder = 3 pulses per revolution
1 pulse represents 120 degree
Is there any away to extract a precision up to 1 degree, Note that the Motor speed is variable + acceleration is non linear.
In...
High Precision Servo Drive using PID via ATmega328p
Have a look at this
https://www.youtube.com/watch?v=pm0rOKYl0K0
Features:
Can deliver a continuous current of 6A & peak current of 12A,
Communicates with Master Manipulator via RS485 (MPCM @ 250kb/s)
Implementation of...
yes u can Remap the Stock ECU fuel maps by over writing the EEPROM, for that u need to remove ur Stock ECU EEPROM or u can do via OBD2 CAN Port by using some sort of Special equipment
Yup u r right man but the problem is that i am just a hobbyist i dont have any SMD PCB Fabrication facility.
LEDs shows the Status of Fuel Injectors, Ignition coils, IAC Position, VVT, Purge Valve, Fuel pump, Radiator Fan etc
hello guys,
I made a Universal Engine Control Unit (ECU) using dsPIC33F equipped with DSP Engine, it can run any Gasoline 1,2,3,4,6,8 Cylinder Engine. it can also support VTEC/VVT, + lot more advance features
Have a look at it
https://www.youtube.com/watch?v=QJekC7DcIqk
Best Regards
Asad
Hello Guys,
i made my own Engine Control Unit ECU using PIC Microcontroller
have a look at it
Engine Control Unit ECU using microcontroller - YouTube
This ECU has following features:
1) Adjustable Idling Speed + Idling Speed Regulation.
2) Cold Start feature for better cranking in...
i have displayed just one phase on oscilloscope because i don't have 3 channels isolated scope, i will try it with three isolation transformers (star to Y) i think then an ordinary 3 channel scope would do the job
its has a Protection dude, if u change direction switch at high RPM it would not take any action first u have to reduce Speed, Direction switch is effective only & only if frequency is with in 10 frequency Range,
my drive is working Great no prblems dude, the motor has high torque even at 5Hz u...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
