Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i m really sorry for it i have very little time to do the project so i have to hurry.............as i told earlier that nothing is displaying on hyper terminal though i tried many times..........
can u pls tel me what is wrong n how to correct.........the printer is printing all the the things dat is in the char in simulator ........please someone help soon........it is not printing only what is there in TXREG it is printing all d char dat s der in STATUS PCL FSR......... What to b...
hi..........the baud rate of the printer is 9600 .........i have not set the BRGH bit ...........is it better to use high speed or low.........if i use high speed the SPBRG=71........is it fine please reply soon
hi.......... i constructed the hardware .......its printing some junk value like v||etghcvbb wen i press the sw instead of label name etc can u tel me wat can be the error ...........wat do i hav to check.........
---------- Post added at 22:48 ---------- Previous post was at 22:48...
yes i wrote the code....... its working perfectly in simulator one character after the other........
but i want it to be like label
name
class
college
will it print like this or label
n
a
m
e
dont no how to c the output
hi......the circuit shown below is to give input to portB.if we press sw1 the label is printed and so on....i wanted to no if the circuit is correct and i wanted to no y 10k resistor is connected to switches and 1k resistor is connected to LED...pls help us soon
---------- Post added at 13:50...
hi my code is working in simulator mode i had to give a delay...........thanks...........but its not displaying in hyperterminal should i make some settings in hyperterminal ..........
hi..........the above code is working in simulator mode perfectly..........the data is perfectly sent to portd but wen i m trying to send the data to txreg only 2 characters l and a of label are displayed the rest characters are not displayed and only two characters of names i.e n and a are...
hi....... the above code is working in simulator mode dut its not displaying on hyperterminal..........can u pls tel me soon what s wrong..........pls help soon
hi .........i hav changed my schematic i m using three switches wen ever i press sw1 the labels should be printed n so on ................i hav to send this data to hyper terminal can u tel me wat to do ...........its working in simulator mode ......should i make some changes in the program pls...
hi.........
can anyone pls help me in programming for my project.......can u pls tel me how to go about it ....wher to start from............pls help me soon.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
