Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
this link wasn't useful for me..because i am not a member of this site & i can't become a member..because i am not the student of the universities specified in this site
anyway thank you for your answer
hello...
please introduce a good & application link or content or text about troubleshooting in electronic circuit so that i understand what is the cause of the problem in my circuit through the samples that are in this link or pdf
i don't want the book about testing components or about how can...
i haven't disabled the interrupt..i just have removed the flags by "clear interrupt" command..
of course i commented this comand but it didn't change anything
i attached the ordered code
so your code hasn't realy used sensor feedback..in your code, we put a array on the output connected to motor...
i had attached the proteus file at already post...
i uploaded it again
setting up BLDC motor in PROTEUS
hello
?what is my problem in this PROTEUS circuit
please help
thanks
I attached the code but i can't attach the proteus file
hello freinds...
I could start up the motor without using the sensors (of course motor doesn't work completely continuous and the speed was very low & there were quiet short stops beetween every rotation )
anyway leave it...
when i want to start up the motor with the sensors,it doesn't move at...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.