Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: TCA8418
Hi,
Friends i got it working some registers were not set and I2c Bus specifications were not met . Kindly let me know if you need the sample codes for this IC.
Post your query to gops2008@gmail.com
Regards
Hi,
Can any body let me know the best method to apply variable torque to a geared motor.
I have a geared motor with torque meter attached to it at the output shaft. Now i need to setup an appartatus to apply variable torque to its shaft so that i can see the torque taken by the motor...
Hi,
I am a design enginner working on TCA8418 keypad controller. we have interfaced a pic 24f processor with it . The i2c bus is pulled up with a 3.3 k pullup resistor and 1.5 k series resistor for voltage drop from 5 v to 3.3 v as the TCA8418 is a 3.3V IC and PIC24f is a 5v chip. Can any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.