Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I am doing a small project of monopole and dipole antennas used in mobile devices.Here,the antennas (made of metal with thickness 0.3 mm) were placed on the inner layer of the mobile casing (casing is made of plastic) and is soldered from the device PCB 50ohm trace using coaxial cable to...
Hai DeboraHarry !
I have attached the hfss file in project1.rar.For your ease of work,i have made the design in HFSS 13 itself so that any modifications you can do if needed.
Please add the lumped port and try to simulate.If it is working good as per the paper shared before,share the hfss file...
Please observe the MIMO antenna.pdf i have attached.
In general,when defining port in hfss,the ground is below the dielectric and the radiating element at the top of dielectric.
But in this design,both the radiating element(monopole antenna) and the ground are on the top of dielectric(fr-4).In...
a similar lambda/4 monopole antenna design i am trying to simulate in hfss but stuck with excitation.please help me how to excite it.i have attahced the pdf i working out for my project.
thanks well in advance!
hello!
I am new to hfss v12 software.
i am designing an usb dongle antenna for mimo applications as a project for my graduation.i am held up at the excitation stage.i have attached the reference paper for clarification.
i have made the structure in hfss but struck at the excitation.i was unable...
hello!
I am new to hfss v12 software.
i am designing an usb dongle antenna for mimo applications as a project for my graduation.i am held up at the excitation stage.i have attached the reference paper for clarification.
i have made the structure in hfss but struck at the excitation.i was unable...
can u please send me also the link of antennas theory to practice book by wiley,
my mail id is gk.kashyap@hotmail.com
That would be helpful a lot for my pg project.
thanks in advance!!!
have a great day.
hi guys!i am designing monopulse comparator with basic block as ratrace coupler as power combiner.
started with basic 3db coupler.
now using baluns concept conversion to 180hybrid i am trying.but i am not getting the required outputs.
details are:
freq-4ghz
fr4 substrate.
i am new to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.