Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Can anybody recognise the four 4 way connectors on this PCB please?. Even a manufacturer would be great, part numbers of male and female components would earn my undying gratitude!. The outside dimensions of the connector are approximately 15 mm by 11 mm as seen in the photo. I cannot remember...
Old thread, I know, but for future reference - while you have hold of the floating via with the cursor, hit TAB to get the properties. Go to the Net drop down and choose the Net that you are going to drop the via onto. That via is now electrically connected to the correct net. I believe the...
Are you doing this for a learning project, or part of a commercial project?. If the latter, you are reinventing the wheel and may be better buying an off the shelf solution.
Git
It just seems like change for no reason to me. The symbols are ambiguous, the message list is back to front and it doesn't even know the difference between Blue and Green. Horrible waste of time, please go back to the old board.
I was going to keep my opinion to myself, but you specifically...
Also, many of us have post count now divided by 3 and this forum only has about 12 pages of threads. I presume they have all gone to the same place as PM attachments and all of the Private forum, >NIL
Git
Re: Spot the VHDL error...
Doh!. I *always* do that!. Thanks very much.
Yes, source was originally indented OK but the tabs got removed when posting. I think there's a posting tag I should have used.
Git
Spot the VHDL error...
Can anybody tell me what is wrong with the attached piece of VHDL please?. Xilinx ISE 7.1 is telling me it expects to see see IF rather than PROCESS near the end. I have looked at it too long if you know what I mean.
TIA
Git
library IEEE;
use IEEE.STD_LOGIC_1164.ALL...
Re: Interview question for job require Protel tool experienc
"What experience do you have of Protel, or have you just been playing around with it?". . . .
Git
Re: 7 segment operation
There are several problems with this circuit.
1) Your switched don't connect to anything on one side so they cannot possibly do anything. For TTL logic, you need to pull each input High to VCC with a 4K7 or similar resistor. Your switch then switched that input to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.