Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey,
what prpblems are you facing..?
Heres an example of using it,using the handyboard(Motorolla 68hC11)..
However its programmed in Interactive C.
You Just need to program the threshold value into the micro(0 to 255)...and when the sensor reaches tht value..the micro triggers an output...
Hey,
well..according to the circuit ,the volage can swing from 0v(no emittter) to around 5V(when emitter is in full view)
I tried making a line following robot :
**broken link removed**
From the schematic ,i would say that the serial port is being used to control the speed and direction of the stepper....The microcontroller,that is the 89c2051 is just decoding the serial commands and delivering appropriate step signals to the stepper.
You could avoid using the serial...
Re: question about PIC
The programming hardware comes with their own softwares for downloading the program to the PIC
zyou may try these sites:
http://www.winpicprog.co.uk/
http://www.ic-prog.com/
_________________________
**ice**
Machinegrid.com :: Robots at Work!!
Hey,I'm new here.
I finally finished building my new webpage..
It's got my Machines,Tutorials,Links to homepages,,material list...,
Few of my Autonomous machines including the Fire Fighting Pyro are put up. and a 2 part Parallel Port Tutorial
I've included a Links page .If you need your...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
