Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Converter DC/DC - HELP
https://www.murata-ps.com/data/power/ncl/tdc_pwr13xx.pdf
I am looking for a voltage booster circuit that will give me a constant Vout of +12V and -12V when Vin ranges from 10.8v to 13.8v. I thought I found what i wanted from farnell. The technical specs of this module...
Inclionometer question..
I have a very newbie question, pls pardon me ...
I have an inclionometer that accepts voltage input of +12V for A and -12V for B.
My question is, must the voltage of B be the exact the reverse of A?
Can B be -12.10V and A be +12.58V? Will it affect the...
U are right, the voltage divder should be 2R:R, based on the calculation.
So, i use the following resistor values,
Rg = 10K, Rp = 20K, Rq = 20K, Rf = 10K, Vp = 5V
Vcc = 5V (LM358)
Vcc- = 0V
With the above calculation, i should get the following Vr based on the Vq value.
Vq = 0, Vr = 2.5v...
I have an inclinometer that outputs a range of -5 to +5v. The output of the inclinometer will be fed to my PIC that can only takes in positive voltage in the range of 0-5V.
I have the following circuit as shown in the attachment. The gain of the op amp is --0.5 in this case.
When I put Vin...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
