Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am a newbie in the design of opamps would like to know your opinion. This is an inverting amplifier with Av = -(R2/R1)
1) The gain depends on R2 and R1 , just what are the factors influence the accuracy of it?
2) What is the load resistor role why is it connected to the non -inverting terminal...
I am a newbie in the design of opamps would like to know your opinion. This is an inverting amplifier with Av = -(R2/R1)
1) The gain depends on R2 and R1 , just what are the factors influence the accuracy of it?
2) What is the load resistor role why is it connected to the non -inverting terminal...
Hi All,
I am doing an experiment on the LEDs. I am looking for a 3-D vertically stacking RGB LED, which basically can display colors. The LED should be able to take in a minimum of 200mA current. what would be the best possible 3D stacking LED or 3D flip-chip that I can use for this? Please let...
Hi All,
I am doing an experiment on the LEDs. I need an RGB LED, which basically can display all possible colors. The LED should be able to take in a minimum of 200mA current. what would be the best possible LED that I can use for this? Please let me know.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.