Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thank you Bad but... telling the truth I was looking for a definitive, stable solution.
If I cannot find the appropriate connector in the market very probably I will turn on the iron and replace the first one with a common RS232 DB9 connector, desoldering/pulling the original one out and leaving...
:bang:
thank you Brad... of course I cannot even think about the usage of a connector like that... :roll:
I've seen some Lemo connectors that seem to perfectly match, the fact is that I do not have any experience with those connectors.
Hi to all.
Hope that somebody could help me.
I cannot identify two circular connectors.
AFAIK they should be push-pull type.
I tried to vectorialize one of them in order to find out the size of the pins and the internal layout's geometry, of course I need to buy the females of them.
thanks in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.