Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Anyone know where to find a mould for a keychain fob (or a pre-made one) which holds an integrated circuit (IC) die. It would nice if it has a dimple on the front that acts as a magnifying glass for the IC die.
Thanks.
P.S.: If you believe this is posted to the wrong forum, let me know where...
Hopefully someone can help solve the following. I am trying to run a sentaurus process simulation and keep getting the error below; after field oxidation growth then nitride and pad oxide removal.
I have tried remeshing by using 'grid remesh' but that didn't make a difference. Also 'grid...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
