Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
OK, so I found this site: http://denishennessy.com/2012/04/08/measuring-battery-capacity-with-an-arduino/
Can I replace the resistor with the high watt I found and use this project and reduce the volt to the Arduino?
Klaus,
That sounds good. Yes, the battery can handle it, its multiples in a series-parallel pack.
I can drop the voltage to about 24 V, and use this resistor I found on the net?
2.4 ohm - 400w Milwaukee 26-136 Ribwound, 1-5/8" x 8-1/2" $49.00
- - - Updated - - -
Would it be better to use a...
Hi,
I was wondering if you guys have a way to load test a 29.6v / 10A lithium battery pack to 10A?
Would a multimeter and a 2.96 Ohm / 296 W resistor work?
Hi,
The coil is transmitting signal, so I don't get why its used H-bridge...
I know H-bridge is used in motors to run the motor one way at the time.
Can you explain how it works here when its transmitting its "bits" thru the coil?
Why is the TX signal sent from both side of the coil? I though...
Im looking into designing a wireless data transmission using two coils.
Tx coil will send a 8 bit data to the Rx coil that sends it to the PC thru USART.
I want to read multiple temperature sensors thru a steel wall. I will be using a Atmega128.
Transmit package:
XX XXXX XX = 8 bits
2 bit...
All,
Have anyone done this:
I want to capture a picture with a camera e.g Omnivision with a Atmel Sam4, send the data thru RS232 to a PC. Then the question, have anyone
seen or made a GUI with Visual Basic Express 2010 to display a captured image from a microcontroller?
Sorry about that, I mean those kits you can buy. Will those kits with that 2.4GHz antenna/electronics be enough power to be received on ground station?
It would be great if that would work, if not I have to build my own. I just cant see that they are powerful enough..?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.