Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sorry for the misunderstanding, I don't know what is the name of this connector, it is like in this picture: It was not dropped, maybe it is a good idea to check switch position or shorts-circuits (on display there is no information about mute).
Hello,
after transporting X-HM36, there is no sound, it is no guilty speakers because even on headphones there is no sound. I was mentioned about transporting, so I guess it is a mechanical issue, after opening housing, I am noticed a lot of "paper connectors", maybe some of them loosened? I am...
@BigBoss - is there possibility to set frequency in Filter guide? I mean matching frequency, not cutoff.
@niki - yes, you right. This is what i want to do, but maybe i described wrong :D
I was thinking about it, and there are not 2 blocks nesescary. 1 block which is filter and matching network...
@niki, and what with impedance in other side?
Maybe i will describe what i want to do to better understanding.
I have 2 matching blocks, A and B. I know impedances: Z1, Z2, Z5 Z6. So at this moment Z3 and Z4 are not important. Now importat is to make a pi filter with some f-cut in B block to...
I want typical PI filter: https://qph.fs.quoracdn.net/main-qimg-072c1b830ccbcae9828f1873046e8c75.webp . The load impedance is 10 + 10j, and the source impedance is any - it will be matched to previous step of design.
Hello. I think this is a property forum.This is a thing, which I think about it more often. Viz, what skills from electronics/electrical engineers are more and more desirable? Well, my favorites thing about electronics are analog design, optics and and RF engineering, and I am doing it at big...
Hello, i do not know if i am asking in property forum, but i did not found a answer. Is it possible to change circuit topology (in shematic), or delete elements in Smith V4.1 (from Frit Dellsperger).
I know there are a lot of same problems on the internet, but there are different solutions, every time when i do this what i read on xilinx forum or other site does not work :(
I am trying to program a XC9536XL with DLC9G platform cable and i have an error in iMPACT:
PROGRESS_START - Starting...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
