Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
@mtwieg: then I am confused. The smallest settings for the diameter is .254mm. However, the smallest drill setting is .5mm.
Also if the green part overlaps on the board file will it overlap on the actual board?
Hello,
What is the difference between drill and diameter in the vias settings?
Also if the "green" part of the vias overlap and they are tented, does that mean that the tents will overlap on the actual board?
Hello,
I am new to PCB design.
I understand the when using an LED we can use a 2 layer Fr-4 with thermal vias. The question is if I want to add an additional heat sink to the bottom of the PCB will that mean I will have to show the copper? If so, how will this prevent solder wicking when...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.