Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your reply. What I'm trying to say is that I will solder the components on the bottom layer so I would like all traces leading to component pads to be on the bottom layer. And I would also prefer all via outside component courtyard if possible.
I'm having problems finding out how to tell Altium not to place a via under the pads when auto routing as you can see in the attached picture. Can anyone tell me how I can resolve this?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
