Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Some DC quesitions
TO asicganesh
I design a system which has to use differential signal .So before the counter there is something whose output signals are differential signals as input signal in the counter.
Re: Some DC quesitions
How to remove ck_ as a input port?
I have remove res_ as a input port.
module counter(out,out_,ck,ck_,res,res_);
input ck,ck_,res,res_;
output [7:0] out;
output [7:0] out_;
wire ck;
wire ck_;
wire res;
wire res_;
wire [7:0] out_;
reg [7:0] out;
always @(posedge ck )...
Re: Some DC quesitions
To asicganesh
Thank you for your answer.
so you mean there is nothing about process when I change verilog HDL to the netlist.
the secound question
I add a file
I am new in DC and have some questions.Plz help me.
I want to change verilog HDL to the netlist,then change the netlist to layout.
Now I use design vision to change verilog HDL to the netlist.
Here is the first question.When I DC the circuit ,there is an Error:Could not read the following target...
Hi everyone.
I want to model the spiral antenna in a RF circuit . How should I take the effect of an antenna into account in a circuit ?
I just think antenna can be modeled as and R,L,C element .
Can anybody tell me detail?
thanks
Thank you very much.
When I simulate the spiral antenna,I saw two types of the port. one type is what I do ,the other type is like
The both types are all right ?And whitch one is better?
thank you
Added after 5 hours 31 minutes:
The other type of the feed structure is like...
Help me
I am using HFSS to simulate a archimedean spiral antenna.
But I am not sure how to feed the structure.
I tried it with a lumped Port between the two spiral arms.
It would be great if somebody could take a look.
Thank you very much
Dear all
I am a student and i am trying to design 2 arm archimedean spiral antenna@60GHz in HFSS 10.
however the simulation result of s11 can not be satisfied.In hfss design, i put lump port in center of spiral, between 2 spiral arms.I want to match it with coaxial 50 ohm.
so how can I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
