Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I'm interested in using an op-amp to drive an AD7823 data convertor.
Maximum gain required is about ~30, since I can use a ref voltage as low as 1.2V on the AD7823. Required bandwidth operation is 100KHz.
I have no requirements on the op-amp except that the supply range should be...
Hello,
I'm programming a development kit which has a Virtex5, to interface with an A2D model (AD7823, Datasheet is linked).
The I/O voltage on the kit is 2.5V, where as the operation mode of the AD7823 is between 2.7v to 5.5v. I/O max switching speed is planned to be 20MHz.
Since the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.