Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
OFDM communication standard frames contain preamble which can be used for synchronization. Simply there are tow similar priambles in the frame, calculate phase difference of these preambles and divide by preamble duration
Re: SDR
I usually do not recommend implementation as academic project.
you can work on sdr using Dr. Mitola book. Software defined radio, An objec oriented ...
Re: MIMO ...
What is spatial multiplexing ?
MIMO data rate = (spatial multiplexing) * SISO Data Rate
Difference between Flat fading and Frequency selective fading?
Flat Fading: Channel Freq. Response is flat over signal bandwidth. So all frequencies encounter the same gain.
Freq. Selective...
bandwidth of bpsk signal
Every communication receiver has limitted bandwidth that determine the amount of noise get into the system. in theory the Receiver bandwidth is the minimum possible bandwidth of the transmitted signal. In practice transmiiter filter has special form that prevent...
Re: How calculate mean square power of an OFDM symbol wth CP
You can calculate power both in frequency domain or time domain. but the prefered method is in time domain (i.e. after IFFT) . In simulink you may use square and moving average to calculate the signal power.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
