Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
sirs.,.,i need help in getting data from LCD display...
i want to read the data from LCD(a) and display it to LCD(b)...
where: LCD(a) has a display output from outer source(device).
LCD(b) is connected to my arduino as my main device.
if you could spare me sample codes...
my arduino is a diecimila w/ ATmega168....does rx tx connection enough already.,.,and the source(3.3v from the arduino)?
---------- Post added at 15:05 ---------- Previous post was at 14:52 ----------
i am supposed to program my arduino to send a message at a given time using the GSM module.,.,
that's a wise thing to do sir.,.that you didn't fall for it,.,.'coz some falls for it..
the best thing to do sir is that not to interact with 'virus software' thing in the internet.,.,usually it pops up out from nowhere...
prevention is better than cure motto is applicable too.
my SIM900d is already been made like some sort of arduino shields...anyways, thanks yadavvlsi...just have to know what pin is needed to be connected on the arduino to be able to read,send and interpret text messages from my GSM module.
thanks sir.
Sir. I would suggest that you avoid clicking ads on the net... some of them have this worms and other viruses...also you should have anti-virus software(personally, i use avast)... and also avoid clicking pop-up ads and sites. Have a regular full system scan :)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.