Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by emyles

  1. E

    Suspected to have LO Leakage Problem

    I supplied the IF with modulated signal. OK, will do check the output on the VSA. Thanks!
  2. E

    Suspected to have LO Leakage Problem

    Hi, I've tried replacing the IF by using test equipment (to generate 10MHz BPSK modulated signal). So, is this the correct output that I should get after integrating the IF with LO of 4.793GHz on a double balancedmixer?
  3. E

    Suspected to have LO Leakage Problem

    I'm using DMY0207M Miteq mixer. It's a double balance mixer. The datasheet can be found here: **broken link removed** Thanks!!!
  4. E

    Suspected to have LO Leakage Problem

    Sorry typo error. BCO = VCO
  5. E

    Suspected to have LO Leakage Problem

    Hi all, I’ve a problem to integrate a mixer, BCO and IF signal of 10MHz as the inputs. However, the result obtained was as shown in Picture 001 in the attachment. Is the result correct? Shall the output be a single mixed spectrum (4.803GHz) only? I suspect it is due to LO leakage problem...
See more

Part and Inventory Search

Back
Top