Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by emwave

  1. E

    Question about µWave's fcmax

    When I simulate a combline fiter in µWave cutoff freqency=20ghz, errors occurred and information displayed as below: ERROR 1: Internal error in project [Combline.circuit_1]: Error for structure spres_31: critical order is exceeded by 166.66666667% INFO in project [Combline.circuit_1]: Structure...
  2. E

    Problem about HFSS & LHM

    Thanks a lot!!!
  3. E

    Symmetry plane of Mician µWave

    ExHughesGuy, thank you so much for your reply!!!
  4. E

    Question about Mician µWave

    How can I setup or modify the "fcmax" ?
  5. E

    Question about Mician µWave

    When I simulate a combline fiter in µWave cutoff freqency=20ghz, errors occurred and information displayed as below: ERROR 1: Internal error in project [Combline.circuit_1]: Error for structure spres_31: critical order is exceeded by 166.66666667% INFO in project [Combline.circuit_1]: Structure...
  6. E

    Symmetry plane of Mician µWave

    A bandpass filter consist of coaxial resonators and dielectric resonators. In order to saving computation time, symmetry plane should be used. Due to the mode nature, magnetic-plane and electric-plane must be applied to coaxial and dielectric resonators respectively, but there is an error...
  7. E

    Question about symmetry plane of Mician µWave

    A bandpass filter consist of coaxial resonators and dielectric resonators. In order to saving computation time, symmetry plane should be used. Due to the mode nature, magnetic-plane and electric-plane must be applied to coaxial and dielectric resonators respectively, but there is an error...
  8. E

    Can HFSS model be changed to RLC equivalent circuit ?

    hfss model A rectangular waveguide with a shunt post in it, and simulated by HFSS. My question is: Can the shunt post be changed to the RLC equivalent circuit? If can, how? Thank you for your help! emwave
  9. E

    Problem about HFSS & LHM

    When I simulate a rectangular waveguide filled with LHM(left handed material) using Ansoft HFSS, but there is an error: [error] Port refinement, process abc3d : subprocess "wave detected an incorrect value for permittivity, permeability, or the loss factors" Why? Thanks a lot...
See more

Part and Inventory Search

Back
Top