Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Never mind, I have found the error in my code - needed to account for the transition delay of the decimation filter. After I discarded those initial bits from the bitstram (the higher the decimation rate - the more bits need to be discarded) the SNR is correct.
I have tried to estimate the SNR of the sigma delta conversion after the sinc^3 filter and got lots of noise at the low frequency end. It looks like the opposite of noise shaping, see attached. When fft of the bitstream is plot the SNR is almost twice as high for the same frequency. Am I using...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
