Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
sim300 at+cipserver
Hi,
I want to sending data from one of gprs module (sim300) to other. I have this:
at+cipcsgp=1,"vodafone.vodafone.ro"
OK
at+cipsrip=1 (show remote IP and port before received data, optional)
OK
at+clport="UDP","7777"
OK
at+cstt
OK
at+ciicr
OK
at+cifsr
172.28.64.184...
Hi, there is anyone which use an usualy phone with GPRS (Siemens M50) to sending data? I make connection with Atmel microcontroller but i don't know to make negotiations...(LCP, PAP/CHAP and IPCP). I read from RCF1332, RFC1570, RFC1662...but I don't understanding very much. Don't geve me...
atmel gsm
I want to connecting ATmega8 with GSM phone via miniUSB. I alredy used GSM to transmit from Tx, Rx pins, but now almost GSM phones have miniUSB connector. My board with Atmel is host for GSM device. Give me advise.
i5062-zd
I have an USB Flash who use i5062-zd from icreate and memory from infineon HYF33DS512800ATC 64x8 Mbytes. How is posible to have 2Gb when is connect to PC? Why can't use than 128M space from Flash?
Regards
Cristy
thanks Egilssk but that (+COPS) give me information about operator, not about cell where the phone is connect. I try to findout an equivalent of AT*E2CD
In my country one of operator (vodafone) transmit name of cell (ex:Central Park), and anyone can to activate that on phone and that apear on screen....
s65 cellinfo
I designed a module with ATMega8 and siemens C45 to transmit data from alarm system but now i want to conect my module with car alarm and wont to know if exist one ATcommand who request infocell (name of cell).
Regards Cristy
connect t105 to pc
I tried to connect sonyericsson T105 to PC via serial but don't work.I used an C45 from Siemens an that work properly. I want to connect with microcontroller for data transmit. I have information about connector from h**p//www.pinout.ru. Any information is useful for me...
Re: Is it difficult to program AVR MCU using Assembly langua
If you now C is easy to programming with C comliper but in assembler you have much more control about resurces (timers,I/O ports, etc..) . I use Assembler ( AVR studio4 from Atmel company).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.