Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I really donnot understand, if you can use hfss, it will be very easy work. I attach a project, which is not very accurate, just an example. hope help you.
Edmund
Dear all
I found that if you renormalize the port impedance to 50ohm, you would get different S11 results though the port impedance was near 50ohm. Can you give me some advice when should I renormalize and what is the reasonable result? Thx in advance!
Regards
Edmund
Hi
I am working on an optical receiver, 10gbps. when input power is high, the eye diagram is good, however, when input power is low, the eyediagram is bad. I attach the pics, please help me, any hints will be appreciated. Thx in advance!
regards
Edmund
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.