Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: regarding mplab icd2
I cannot post the schematic...but its just simple.I gave the following connections.
Vdd-5v,Vss -ground,4Mhz crystal at osc pins.Avdd-Vdd.AVss-Vss and i gave the connections from icd 2.
I have specified the pic in mplab.I unchecked the 'power target from icd2;auto...
I am using mplab icd 2 programmer for programming dspic30f4012 controller..
I gave all the supply connections correctly but i am getting the following error.
Auto-connect not enabled - Not connecting (Try enabling auto-connect on the ICD2 settings pages.)
Connecting to MPLAB ICD 2
...Connected...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
