Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am pretty positive I have it wired up right. The problem is that for some reason both transistors turn on when only one of them is supposed to be on. Instead of using the 10 ohm resistor, I used a 100kohm resistor and it worked like it was supposed to, but the resistance is too large for my...
Are you saying that we should wire everything on the gate (as shown "currently") to the drain instead and vise versa (everything shown on the drain currently to the gate)?
I'm working on a project that requires paralleling of 2 mosfets. I attached the wiring diagram for just the two mosfets below. Basically the gate on each mosfet is connected to their respective pin on a PIC microcontroller. When the respective pin is high, the respective MOSFET is turned on and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.