Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I moved to Linux 10 years ago, mainly I because I did not want to pay the Micrsoft Licence fee.
There is the other problem of installing Windows applications required and find that 5 other appication not required had been installed.
As others have said no viruses, do not crash, always...
Hi,
If the .brd file or PCB file is not present, then you have a big problem.
The teverse engineering of PCBs from Gerber files is very difficult.
Gerber files are the construction files that the PCB manufacturer uses to manufactute the PCB.
I have used KiCad and Altium to import the Getber...
Hi BR,
You are quite correct, the component does look like a SMD 33 Ohm Resistor.
I checked the Internet for photographs of the Game Boy Micro PCB, which shows the picture attached below.
The correct component should be an SMD Fuse, so it appears that someone has replaced the Fuse with a 33...
Hi,
I need some advice, I have a Game Boy Micro to repair, with has no power from the battery or charger.
I am told the battery is new and fully charged, the charger is fully working texted on another similiar console.
On examing the console PCB there is an SMD Fuse F1 that has blown.
I am...
Hi,
Sorry for the spelling mistake in my last post, I really mean to say "FPGA"
And again thank you for the clarification on the damage to the FPGA, I am waiting on a new part to solder in place.
Hi,
Thanks for the replies, I have verified that the programmer is working, so I guess the FPGS is damaged.
I will have remove the LPX2 and fit a new one.
HI,
I need some advice, I was programming a Lattice LPX2-8E-5TQFP144, with an updated FPGA code.
But I got the programming pins on the JEDEC interface the wrong way around, the correct pin connection should be:
Pin Function
1. Vcc
2. TDO
3. TDI
4. TMS
5. GND
6...
hI,
I need to program ALTERA EP1810LC-25 chips, the ALLO3A programmer I have indicates that adapter ADP-1810PLCC/PGA is required to perform the programming.
I have searched on the ALL03A resources web pages, but details of such adapter is availble.
Does anyone know where I can get this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
