Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
no just a 4-bit counter....but its a little complicated because i have to add next a second 74LS175N (8-bit of memory ) that need to have common input channel and we were said to use the tri state buffer 74LS126N.....and from the two chips the signal goes to both LEDS and Seven-Segment.
So...
Hello to all. I am new to working with electronics and i am confused a little bit. I already have installed a 74LS175N chip (quad flip-flop with CLR/ CLK) and connected LEDS, switches, VCC and GND. It works perfectly. Now i have to connect the signal to enter a 74LS47N BCD Decoder and after this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.