Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Not so sure ashugtiwari.
If the door is left open after the LED has timed out, the 555 is still held under power.
I need the timer to disconnect from power after its cycle.
Perfect Betwixt. Thanks!
I will give it a go.
What value would you use for the LED resistor for a simple white 5mm LED?
I am also presuming to shorten the "On" time I just need to reduce the value of either of the RC network?
Thanks ashugtiwari and betwixt.
I should have mentioned that this needs to be low cost, small and simple.
Betwixt, are you able to suggest a circuit diagram I might try?
My tech skills and understanding are moderate so simple works for me :).
I am building a battery powered device (preferably 6v from 4xAA’s) that will drive about 5-10 bright LED’s for 10-15 seconds when a door is opened.
When LED’s power off I would like power to be automatically disconnected altogether so there is zero residual current.
There should be a trigger...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.