Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I’m designing a matching network at TLs, and I’m observing a dependence of network input impedance on open stub length using ADS co-simulation. I tried it by two ways – first, I placed input port directly at point of the open stub connection. The second one is by using a TL section 10mm length...
Hi, all!
I faced with the following error in ADS2017 during co-simulation:
--- ERROR ---------------------------------------------------------------------
A calibrated pin must not be positioned on an edge on which other pins are positioned. (Using a single calibrated pin simultaneously...
Thanks for reply, but it does not work for me. I use ADS 2017 and there I set the "Parameterized sub network Pcell" in Customize Pcell dialog, but it didn't help me. Also you use EM simulation/Model in your appnote, but I use EM Cosimulation mode in EMsetup. I suspect that the parameter L1 was...
Hi!
I'm designing an input matching network for GaN transistor. I calculated and simulated it in ADS using transmission line theory and S-parameters block. After, I generated layout and want to tune it using EM co-simulation at the fixed frequency 2 GHz. I set length of the MLin L1 in schematic...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.