Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,everybody,I got one problem about CentOS6.5.When I reboot my eth0
service network restart
Shutting down interface eth0: [ OK ]
Shutting down loopback interface: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: Determining if ip address 10.0.1.67 is already in use for...
Hi All
i have 2 switch one is catalyst 2950 and other are huawei s2300 i want to make redundant link the proablem is that there is no spanning tree instance on huawei switch and but on catalyst 2950 i enable rapid pvst
catalyst 2950 huawei...
Hi everyone!
What is the best way for restore devices to their default configurations? I got two units of cisco WS-C2960S-24TS-L, but they have configure files and vlan configure, so I want to reset them.I want to simulate this situation on gns3. May I get it?
I know these:
- use the erase...
I am attempting to move the "Native" (Cisco Term), Untagged (Huawei Term) from VLAN 1 to VLAN 700.
I have a Trunk "TRK1" on the Huawei S5700-24TP-SI-AC aggregating 8 Gig Interfaces together connectng to an EtherChannel on the Cisco 6506 which is also aggregating 8 Gig Interfaces together...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
