Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello!
I'd like to know how it is possible to set a user-defined number of mesh elements for a simple wire in CST. By default it seems to be determined by the upper frequency of the simulation and the 'cells per wavelength' option, but I'd like to set a specific number of equidistant mesh...
Hello Klaus,
yes I tried
.FileName "C:\Users\ZTSMT\Desktop\Ückerseifer\Basiswechsel\CST\Daten\Draht\HIRF\Moden\mode 1.txt"
but it did not work, unfortunately!
Hello everybody,
I export surface currents calculated by CST on a PEC cylinder using the following code:
Sub Main ()
SelectTreeItem ("2D/3D Results\Surface Current\surface current (f=30) [Mode 1]")
With ASCIIExport
.Reset
.FileName "mode 1.txt"
.Execute
End With
End Sub
By...
Thank you for your response!
For me solution 1) sounds most promising, as 3) would excite all frequencies. Assuming I want to do an excitation at three different frequencies (10MHz, 20 MHz and 30 MHz), which are simultaneously excited. How would this be implemented in CST in detail, so which...
Hello everyone,
I would like to excite an object via a single discrete port. The excitation is somewhat complicated in the sense that I need to excite only a couple of discrete frequencies with each a selectable amplitude. All frequencies shall be excited simultaneously by the discrete port...
Hello,
I am doing EMC simulations in CST using plane wave excitations. Is there any way to directly obtain the power of a plane wave in CST? As a user you can only set the electric field strength, but I need the input power corresponding to the electric field strength.
Thank you very much for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
