Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Problem Solved ... I used Virtual serial port Emulator and mapped my physical port where my HW is connected to virtual port where my proteus COMPIM was connected...
Yes i am able to send data from pc using hyperterminal to my hardware. Refer my second picture which shows "No Disc" in hyperterminal, which i got from my hardware. and regarding "communication program using VB.Net" suggest me some reference as i am new to that.
Thanks..
- - - Updated - - -...
I have set the baud rate to 9600.. check the image for setting..
- - - Updated - - -
I have assigned COM1 in proteus for COMPIM.. and assigned COM1 for my hardware through device manager(refer image showing serial to usb converter connected in com1). and no other COM1 port run in parallel...
I wanted to connect my hardware to proteus through UART. I have used COMPIM DEMO model provided by proteus under sample circuit. I connected my hardware through Serial to USB converter. But i dint to get anything in proteus.
I just wanted to know whether the COMPIM works with serial to USB...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
