Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I know capacitor doesnt do the stepping function I just want to do any settings so that it will not step up-down with just 1-2 volt difference..
in pcb the preset controls the relay.... there are 4 preset for controlling the 3 relay but I dont know where is its optimum position ....I have done...
u didnt got my point ... lets say if the voltage is 210v if it changes to 209v it starts step up & when it again become 210 it step down ... & when the voltage fluctuate between 208v-210v the stabilizer goes on loop of step up - step down... that makes the problem so i was just want to know how...
hi.. in my voltage stabilizer (relay operated) the relay make noise (tak tak) & even if there is very little voltage fluctuation in input the relay step up- & step down the stabilizer as a result some electronics components gets restarts...
so i just want to know how to smoothen the the voltage...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
