Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i have tried option 1 since i dont know how to use current control voltage source. i have put ISIN like in image below. is it correct the way i put it?
after simulating it here is the output result.
******************************************************************************...
hi,
i'm, trying to get drain current noise (A²/Hz) in pspice. below is the example of output simulation that i have. the output only have the information of drain voltage noise (V2/Hz).did anyone know how to get drain current noise? really hope someone can help me..
**** NOISE ANALYSIS...
hi, i hope someone can help me with this problem. i have simulate the circuit and get the result like below:
**** MOSFET SQUARED NOISE VOLTAGES (SQ V/HZ)
M_M1 M_M2
RD 5.237E-29 3.702E-28
RS 4.863E-30 9.763E-25
RG 3.657E-30 8.252E-21
RB...
hi, im to pspice and currently doing a project to determine flicker noise in NMOS transistor. the problem now is when i set for noise enabled and simulate it, the output simulation will give result as below:
* Analysis setup **
.ac DEC 10 0 5
-----------$
ERROR -- Invalid value
.noise...
hi, I'm doing a project about flicker noise and it use CMOS LC oscillator circuit. i have successfully simulated the circuit without error but when I'm trying to get the result, the value that i obtained is zero. i don't know why it happen like that.i have set all the value as in the figure ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.