Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I'm trying to program CFI Flash Device trough the CPLD system controller that is Parallel Flash Loader IP (PFL).
All the time I have the same error message:
Error (209025): Can't recognize silicon ID for device 2
Error (209012): Operation failed
I checked all CPLD pins to be set as tri...
Hi!
There is a Cyclone 4 Development Board. MAX II CPLD is on the board.
My purpose is to configure Cyclone 4 FPGA through Parallel Flash Loader (PFL) that is inside MAX II in Fast Passive Parallel Mode (FPP).
My steps are following:
- Attach specified .pof file to MAX II CPLD that is in...
Hi,
I try to convert .sof desing file to .flash using Nios 2 flash programmer to dolwnload to CFI 64MB Flash.
Being in the folder the design is located, I type the following in console
> sof2flash --input=proto_fpga_sm.sof --output=proto_fpga_sm.flash --offset=4E0000 --pfl...
I faced with the problem and if anybody could help me I would be pleased.
So, the problem is - I try to program FLASH CFI device 64Mb that is on the Cyclone 4 DB.
My actions are following:
press auto-detect in quartus programmer -> the chain of fpga and cpld is shown below,
attach flash...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
