Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need to switch on and off the usb D+ and D- lines via the GPIO of a Raspberry Pi and I used 74HC4066. Unfortunately this IC is breaking the USB signal and it is not stable at all - constantly disconnecting or hanging. I have attached a high speed USB 2.0 device. Probably I need a suggestion...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
