Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
de embedding hfss
"you can simply define deembedding in the port preferences."
The port preferences you are refering to here, are they found in the 'Source/Boundary Manager' or the 'Post Process'?
deembed hfss
hi pigkiller and anyone who can advice
your step 3, "calculate" refers to...?
i cannot find any calculate button...
right now i am learning how to perform de-embedding on my structure, but unsure abt the subsequent steps after i enter my vector length for de-embed.
looking...
lumped gap sources hfss
rugbyfun,
i think it works, thanks.. heres another question... if i have a piece of metal over an oxide layer and a substrate, and i want to find the s parameters of the metal (refer to the picture) How do i assign the ports if i use Lumped gap source, now that i dont...
lumped ports silicon substrate
Thanks, but i have looked at some of the articles but i couldnt find any description on how to define a port..
I'm using HFSS 8.5 and i believe there is a choice of eigenmode or driven solution.. i chose driven.
So far i have been getting an error message that...
lumped port calibration
HFSS newbie here
I am trying to simulate an Interconnect line test structure mouted on a Silicon substrate. Its basically 2 lines in Parallel and i need to define 2 ports on either side to get the S Parameters. Question is, If I use Lumped Gap source to define the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
