Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi dear guys,
I have got a problem with this BASCOM program either. I have added my own code at the starting point of the code and it's working right now. but there is a problem with it's speed. the text is being displayed on the LCD and the Temp and Humidity is being measured but the texts are...
hi
I have got this circuit from the Internet which is a simple humidity measurement circuit. i have built the circuit on a breadboard, but it's not functioning properly. It only shows the humidity 99 percent. Even i have manually connected the input pins of the MCU (pin one to eight) to vcc and...
There was a check box in the project options->Output tab->Create Hex file
This check box (create hex file) should be checked to make the output hex file.
More over it was a misinterpretation that there is a mistake with line 46. The error msg was L46 and i got that this wants to say "Line46". in...
hi
This code is for a Humidity Measurement circuit that i got from internet. but when i try to compile the source code with Keil C51, it gives a warning on 46th line and terminates the compilation process. but unfortunately i can't catch the problem. could anyone check the code and correct...
hi dear friends,
I'm about to build a Thickness meter with the precision of Micrometer.
I was wondering if using ultrasonic or laser. ultrasonic is capable of doing it or not?
putting any sample code using AVR MCU would be appreciated.
Please fully explain your claims.
Thanks in advance
hi all people
recently i wanted to upgrade my DSL modem but unfortunately it crashed while updating the firmware. So, already it is malfunctioning or it's better to say that it is not working anymore. Internet and Power LEDs are always light up. and I can not access the configuration page via...
hi all people out there,
could anyone guide me how i can modify this power circuit to have 40V in the output????
I have built the circuit with Multisim but it's not functioning properly. it just shows 17V in the output.
plz explain them scientifically
here is the main link to the circuit...
to test your psu, you need to short the Green wire which is PS_ON (it must have TTL 5V by default) to a black wire.then after a period almost about 200-500 ms, a logical high voltage must appear on the Grey wire which is the PS-Good signal. if PS-Good signal was ok either, you can be sure about...
then you'd better change automatically being restart option from this path:
System properties --> Advanced system settings --> "Settings" botton from Start up and recovery
remove the tick from Automatically restart
hey, are you testing your components with the apps I mentioned or not?
use this...
what do u mean by not shutting down properly? do u mean a cold shutdown?
do u run any specific application? I mean if it is processing at the instant of this problem? the best approach is to put the cpu temp under control by the related apps.
check if it goes further than 40 degrees or not? It...
Re: suddenly shut down
As the others mentioned, your SMPS is malfunctioning. measure the voltage on the grey wire of the PSU. It must be 3-5v. if the other voltages were ok but this one, there is a problem with your psu.
maybe it's due to overheating or faulty Ram. You need to check it to make sure about the components.
It's highly recommended to put it on stress by Prime95,BurnInTest,etc applications while checking the CPU temp
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.