Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have created a GUI in MATLAB to send and receive data from a terminal but am able to send the data to the terminal but not able to receive any data from terminal when it is sending something pls help me in receiving data.
Hello all
I want to send some data on to a terminal in another PC using some code in MATLAB and want to receive the data from the terminal using serial port communication and I just want some code and please any one help in that ASAP.
sorry to say this again am getting the below result when i did as u said
**** INCLUDING SCHEMATIC1.net ****
* source LM385VR
X_D1 N00935 N00372 LM385
R_R1 N00202 N00372 1k
R_R2 0 N00935 120k
R_R3 0 N00229 100
V_V1 N00372 0 15Vdc
**** RESUMING...
sorry to say this again am getting the below result when i did as u said
**** INCLUDING SCHEMATIC1.net ****
* source LM385VR
X_D1 N00935 N00372 LM385
R_R1 N00202 N00372 1k
R_R2 0 N00935 120k
R_R3 0 N00229 100
V_V1 N00372 0 15Vdc
**** RESUMING...
its not a opamp its a micropower 3-terminal adjustable band-gap voltage reference diode and am not supposed to use a opamp
in the link u can see what i really want
in page9 there is a current source circuit and i want to simulate it pls give me the library location of lm385 to be used if...
please some one tell me why am getting the error to connect more than one connection at the transistors emitter and at LM385 as in the fig.
the following is the error generated
.INC "..\SCHEMATIC1.net"
**** INCLUDING SCHEMATIC1.net ****
* source LM3588
R_R1 0 N03080 120k
R_R2...
sorry for the wrong info its not topwin 6.30 its just topwin6 and u can get it from the link which am placing here
**broken link removed**
am not sure for all the microcontrollers but works for many.
the steps followed in writing and locking hex files on microcontroller
for this u need to have a programmer and topwin ver6.30 installed on ur pc
Double click on topwin icon on desktop then a window opens
in that you can see many icons side by side
load file to buffer-->save buffer to a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.