Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Kindly just tell me the capacitance value of the capacitor to be used in this application or in this case ?
I'm not getting completely what you are trying to teach me ..... As it is a 24 VDC and 2.0 Amps capacitor which is connected across the output of a bridge rectifier which is providing 24...
what values must be suitable than ?
how to calculate the reactance of capacitor and also the load impedance ?
what do you mean by lowest working frequency ? as this capacitor would be in dc and dc has no frequency ...........
What is the range for LV (Low Voltage), Medium Voltage (MV) and HV (High Volt) ?
If we have all these types of cables (LV, MV and HV) how to route them ?
Should we route them underground and in single cable tray or in different cable trays to avoid capacitance effect if any ?
Hi
I have a strange kind of problem that i am facing with my AC Split , the AC Split is 1.5 tonns having Running Rated Amps 7.5 Amps .....
The problem is that when i switch on my AC Split and as its compressor starts it takes around 7.5 Amps load (as it should be cause its normal) but after 4...
What are the types of Electric/Electronics Timers ?
Can we use On Delay timer in place of Off Delay Timer & Vice Versa ?
thanks in advance
- - - Updated - - -
What are these modes of a Timer ?
a) Pulse ON delay (b) Pulse ON Flicker (c) Pulse Flicker (d) Differential ON/OFF delay (e)...
How many amps should a one ton AC consume or usually a 1 ton ac draws how many amps ?
And how much time does a split ac usually take to reach its rated or maximum amperage ?
thanks
Is it harmful for TV & monitors if we put a telephone set (contains magnet) over them
Is it harmful for TV & monitors if we put a telephone set (contains magnet/speaker) over them ?
Or
closing the magnets or speakers nearer to TVs & monitors ?
thanks
How to figure out that one ?
" - Motor may start but will always fall short of normal operating speed. "
How to find out whether normal is running below its normal operating speed ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.