Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
How could I design circuit breaker operates when source voltage is between 200 to 250 otherwise it cut the power source automatically, and operate again when voltage is in range. to protect devices.
thanks
what do you think is better in DSP and realtime signal interfaced with USB ??
i have Matlab and C sharp to choose between....
i need the advantages and disadvantages of each way..
the hardware is build by flow sensor and PIC18f4550.
thanx alot
I need to build a project and i have a flow sensor ( 0 to 5 volt output) and i need to display this signal by matlab GUI and DSP.
but, How to use sound card as an ADC and DAQ ??
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.