Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi everyone
i obtain different results when i run my hfss design compared to analytical and moment codes for the same geometry of the problem.
if any one can see the reason behind this, tell me?
the analytical and numerical result, both of them are around 0.80 for S11 and hfss gives 0.54.
i...
Hi everyone,
I have a problem with PML for circular waveguide in HFSS.
For testing PML, i just created an empty waveguide and excited it with waveport. At the other end of waveguide, i tried to end it with perfect matched layer.
What I ought to see whenever I plot the magnitude of S11 is a...
ok.. it's all done folks. all i did was just assign air volume inside the waveguide and plotting the electric field, just simply select the volume "air".
regards
What I actually try to do is to observe the electric field distribution from (0,Φ',z') to (a,Φ',z') where a is the radius of waveguide for constant Φ',z' at start and end points.
If I draw a line on Waveport, I can observe the electric field distribution along the line.
Even if I draw my...
Tnx elchiquito;
No I did not assign a material and actually i could not although i've tried. I send my file. There are 8 lines and two sheets. Also i cannot observe electric field distributions on sheets.
best wishes.
Hi everyone
I'm stucked in HFSS. What i'm trying to do is just simple.
I excite my CIRCULAR WAVEGUIDE and just want to see electric field distribution on a line that lies on the cross-section of waveguide.
Whenever i complete my solution and click right on the line and plot field>electric...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
