Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I must use chroma 63205 for high power battery test.I need to control the load by external waveform with TTL Signal. Arbitrary waveform generator solves my problem but i dont have it. I can use NI DAQmx with labview interface for programming load. But i dont know anything about external...
Hi,
i am planning to use a piezo to harvest energy from flying object vibrations (aircraft,missile, etc.). I was wondering is there any piezo to support these energy requirements. This is probably impossible but i am searching it. Can someone give me any information?
i have created an array with 4 elements.
The pattern in matlab is great.
i designed same array on HFSS, the result is awful but it looks similar. There are some symmetry problems along y axis. Radiation pattern on phi plane (at theta=90) is not same as matlab. i must figure it out What can...
Hi,
I am trying design a basic array that has 2 elements. I want to create Cardioid Pattern, the distance between two antenna is quarter wavelength and phases are 0 and 90 degree. But the result is not correct. Can someone help me to find what i am doing wrong?
hi everyone i am a beginner and i have a project "design a basic model for simulating performance of thermal battery" how should i start ? can someone help me
my professor wanted me to design 2x2 antenna array which gives a pattern similar to cardioid but it has to be 1 everywhere except a narrow notch point. i have been trying 2 weeks around 2000 combination but i still can't find it. my matlab code is :
clear all
f = 1e6;
c =...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.