Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by csr1981

  1. C

    Require circuit diagram

    Well that way i will get only 6 pulses. However i want 6+1 pulses that is 7 pulses. Out of which 6 are equidistant and the +1 is equidistant from 6th pulse.
  2. C

    Require circuit diagram

    Hello John Here is the circuit diagram.
  3. C

    Using EEPROM for waveform generation

    I want to store this pattern in EEPROM and access it i.e. when address on EEPROM pins is 000000 it should output 0 when address is 000001 it should output 1 and so on upto 111011.
  4. C

    Require circuit diagram

    Thanks again John. The logic worked. Can you give me the logic to implement the ouput as attached below.
  5. C

    Proteus Error while simulating 2732

    thanks for the reply Zuitsi. I want to write the data (attached in the file below) in the EEPROM. can you please tell how to do that in the Intel HEX format.
  6. C

    Require circuit diagram

    Thanks John for the circuit. However the output of the circuit is not working for me as i want the output to be like the file attached below.
  7. C

    Proteus Error while simulating 2732

    I am getting the error when trying ti simulate 2732 IC in proteus Please help.
  8. C

    Require circuit diagram

    Hello All, I have mod-60 counter. Using this circuit i want to generate a waveform.For example when the counter in counting 0 i should get out put as 1 when it counting 1 the output should be 0 when it is counting 2 the output should be 1 when it is counting 3 the output should be 0 ......when...
  9. C

    Using EEPROM for waveform generation

    I want to use the EEPROM to store certain binary values and generate a typical waveform. Can anybody tell me how to do this. How to write the code in the hex editor. I am using Proteus for simulation. Thanks.
  10. C

    Help me generate two signals (as on attached pictures)

    Re: Signal Generation Can anybody give me PIC microcontroller based circuit for above signals.
  11. C

    4x4 Keypad interfacing to PIC18f458

    Hello thetravellerzt here is the ckt in Proteus
  12. C

    4x4 Keypad interfacing to PIC18f458

    Hi thetravellerzt the PIC18f458 i shown above in the circuit is the one drawn in OrCad.
  13. C

    Help me generate two signals (as on attached pictures)

    Re: Signal Generation Hello pavel_adameyko Can you please give me the schematic if possible. I tried the idea you gave but was not successful Thanks.
  14. C

    Help me generate two signals (as on attached pictures)

    I want to generate the signal as per the drawing attached. Can anyone please help me on this Thanks.
  15. C

    Pattern generator using PIC

    I want to generate the waveform shown in attachment below using PIC18F458. The frequency is variable but the pulses should be as shown in the image. Please give your ideas.
See more

Part and Inventory Search

Back
Top